5-18 CHASSIS
• Install the O-rings.
• Apply SUZUKI SUPER GREASE “A” to the O-rings and cam-
shaft.
X
99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent)
• Align the punched mark
A
of the brake cam lever with the slit
B
of the front brake camshaft.
• Apply SUZUKI SUPER GREASE “A” to the front brake cam-
shaft and pin, and then install the brake shoes.
X
99000-25010: SUZUKI SUPER GREASE “A” or equivalent
#
• Install the front wheel hub and spring.
• Tighten front brake cam lever nut to the specified torque.
" Front brake cam lever nut: 8 N·m (0.8 kgf·m, 6.0 Ib-ft)
The removed O-rings must be replaced with new ones.
Be careful not to apply too much grease to the cam
shaft and pin. If grease gets on the lining, brake slip-
page will result.
To Next Page
Loading...
