CHASSIS 5-25
• Tighten the tie rod end nut to the specified torque and install
the cotter pin.
" Tie rod end nut: 50 N·m (5.0 kgf·m, 36.0 Ib-ft)
NOTE:
Make sure that the steering turns smoothly in both directions.
• Install the front brake. (
5-16)
• Install the front grip. (
5-7)
• Install the front wheel. (
5-9)
After installing the front brake and front suspension, adjust the
following items.
* Front brake lever play. (
2-20)
STEERING
• Remove the front fender. (
5-5)
• Remove the front suspension. (
5-22)
• Remove the steering head cover
1
.
• Remove the right grip
2
, front brake lever
3
.
• Remove the left grip
4
, left handle switch
5
and rear brake
lever
6
.
• Disconnect the left handle switch coupler
7
and parking
brake switch coupler
8
.
The removed cotter pin must be replaced with a new
one.
To Next Page
Loading...
