3-54 ENGINE
CLUTCH SHOE INSPECTION
Inspect the boss and centrifugal weight fulcrum sections for
looseness, damage and operation.
Inspect the clutch shoe for damage and fouling with oil on the
surface.
If any abnormality is found, replace the clutch shoe assembly
with a new one.
Measure the thickness of clutch shoe at the center position.
If the thickness is less than the service limit, replace the clutch
shoe assembly with a new one.
Clutch shoe thickness:
Service Limit: 2.5 mm (0.098 in)
\ 09900-20102: Vernier calipers
CLUTCH HOUSING INSPECTION
Inspect the clutch housing for any abnormal surface damage.
Measure the inside diameter of the clutch housing.
If the measurement exceeds the service limit, replace the clutch
housing with a new one.
Clutch housing I.D.:
Service Limit: 110.5 mm (4.350 in)
MOVABLE DRIVEN FACE SPRING INSPECTION
Measure the movable driven face spring free length with a ver-
nier calipers.
If the length is less than the service limit, replace the spring with
a new one.
Movable driven face spring free length:
Service Limit: 99.8 mm (3.929 in)
\ 09900-20102: Vernier calipers
To Next Page
Loading...
