Swan Analytical Instruments AMI - Changing Parameters or Values; Sequence: Cycle Time: Channel 1-6

AMI Sample Sequencer
Operation
A-96.250.661 / 120418 49
5.4. Changing Parameters or Values
Changing
parameters
The following example shows how to change the cycle time:
1 Select the parameter you want to
change.
2 Press <Enter>.
3 Press [ ] or [ ] key to
highlight the required parameter.
4 Press <Enter> to confirm the se-
lection or <Exit> to keep the previ-
ous parameter).
 The selected parameter is
indicated (but not saved yet).
5 Press <Exit>.
 Yes is highlighted.
6 Press <Enter> to save the new pa-
rameter.
 The system reboots, the new
parameter is set.
5.1.5.1
Cycle Time
Channel 1 30 Mlin
Channel 2 30 Min
Channel 3 30 Min
Channel 4 30 Min
Channel 5 30 Min
5.1.5.1
Cycle Time
Channel 2 30 Min
Channel 3 30 Min
Channel 4 30 Min
Channel 5 30 Min
Channel 1 15 Min
5.1.5.1
Cycle Time
Channel 1l 15 Min
Channel 2 30 Min
Channel 3 30 Min
Channel 4 30 Min
Channel 5 30 Min
5.1.5.1
Cycle Time
Channel 1 15 Min
Channel 4 30 Min
Channel 5 30 Min
Channel 2 30 Min
No
Save ?
Yes
Channel 3 30 Min