Swan Analytical Instruments AMI - Replacing Fuses; Longer Stop of Operation

52 A-96.250.661 / 120418
AMI Sample Sequencer
Maintenance
6.4. Replacing Fuses
WARNING
Risk of electrical shock
Do not perform any work on electrical components if the trans-
mitter is switched on. Failure to follow safety instructions could
result in serious injury or death.
 Disconnect the instrument from the mains before opening the
cover.
Find and repair the cause for the short circuit before replacing the
fuse.
Use tweezers or needle-nosed pliers to remove the defective fuse.
Use original fuses provided by SWAN only.
6.5. Longer Stop of Operation
1 Stop sample flow.
2 Shut off power of the instrument.
A 1 AT/250V Instrument power supply
A