24 A-96.250.661 / 120418
AMI Sample Sequencer
Installation
3.2. Install the AMI Sample Sequencer
The first part of this chapter describes the preparing and placing of
the system for use.
The analyzer must only be installed by trained personnel.
Mount the instrument in vertical position.
For ease of operation mount it so that the display is at eye
level.
For the installation a kit containing the following installation
material is available:
– 4 Screws 8x60 mm
– 4 Dowels
– 4 Washers 8.4/24 mm
Mounting re-
quirements
The instrument is only intended for indoor installation.
For dimensions see picture Dimensions, p. 21.
To Next Page
Loading...
