Swan Analytical Instruments AMI - Firmware Settings (Mode <Internal>)

40 A-96.250.661 / 120418
AMI Sample Sequencer
Installation
Signal outputs
1 to 6 to PLC
The Outputs 1 to 6 to a PLC are used to transfer the current posi-
tion of the AMI Sample Sequencer’s 6-way valve.
3.5.4 Firmware Settings (Mode <Internal>)
AMI Sample
Sequencer
In menu 5.1.1 <Installation/Sequence/Mode> set Mode to
<Internal>, further information see chapter 9 Program List and Ex-
planations, p. 58, Section 5.1 Sequence, p. 60.
In menu 5.1.2 <Installation/Sequence/Signal Inputs> Signal Inputs
can be set to:
 1
or
 2
Further information see Current Outputs, p. 37.
AMI analyzer No firmware settings necessary.