11
+ +
6/ Select language by pressing 2 then 2 then 3 and then 1,2 or 3 (see chap.. 1.6.11).
This selection is memorized permanently by the unit (along with all other data).
7/ Where necessary, convert from metric to imperial measurement by pressing mm/inch key.
8/ Specify the readout resolution by pressing Resol key and then 1,2,3 or 4 (Section 1.6.4).
9/ If required (refer to Section. 1.6.3) :
Reverse direction of probe measurement. (Channel + (+/-))
Select diameter mode (* 2)or any other multiplication factor. (Channel + Channel)
Select measuring channel if several probes (or channels) are used, and A +/- B or A+/-B+/-C mode if necessary.
Change probe – channel allocation or allocate a channel to an Opto-RS232 instrument.
10/ If required, connect the foot pedal or other external contact (section 1.8.6) and assign its function(refer to section
1.6.11). It is also possible to connect a printer to the Centronics output (section 1.8.1) and set up transmission
parameters (section. 1.6.14). It is equally possible to connect an analog printer to the analog output (section
1.8.3) and command devices (e.g. electro-valve) on sort outputs (section 1.8.3). It is possible to use a D110
vacuum pneumatic lifting unit (section 5) and configure the external contact (section 1.6.11) in order to lift/lower
probes.
11/ Reset display to zero or to any probe reference value by pressing Preset key. The stored preset value may be
entered with Setup key then Preset key (section. 1.6.10).
12/ The displayed measurement can be accompanied by :
the analog scale (section 1.6.6)
tolerances (section 1.6.7) or classification (section 1.6.8) indicators.
min/max mode (section 1.6.12)
store mode for statistics (section 1.6.15 and 1.6.9)
scanning mode if one or more D102/D108/D104 units are used. (section 1.6.13).
13/ Once the unit has been set up, the keyboard can be locked. The external contact and Print key remain active.
The mm/inch function can also be locked.
To Next Page
Loading...
