51
The following will appear if the 1st choice is selected :
Pressing the clear key erases the last stored value.
The enter key will recover erased value(s). When the last stored value is displayed, this key will quit the stored
values display.
The store key saves correction (s) and quits the table.
The print key outputs stored values to the RS232/Centronics ports, from first to last, according to the selected Print
format (refer to section 1.6.14 : Print key).
Once all data have been transmitted, the unit asks if you wish to :
- keep stored values Æ press Enter key.
- erase stored values for current channel Æ press Clear key
Printing of stored values may also be requested from the computer (refer to remote command). The Xon/Xoff
protocol can be used by the computer for transmission control.
In Scanning mode, Setup + Store asks you which channel you wish to work on. If you reply with 0, the stored values
of all channels are printed.
To Next Page
Loading...
