Sym VS150 - Removal of Engine Hanger Bush

7. ENGINE REMOVAL
Removal of Engine Hanger Bush
7-6
Check if engine hanger bush and cushion rubber
bush for damage.
Pressing out
If engine hanger and the rear cushion rubber bush
damaged. Then with the bush remover/presser,
Ø 30mm & Ø 22mm to press the bush out, and
replace it with new one.
Engine hanger bush: ψ 30mm
Rear cushion bush: ψ 22mm
Place the detent section of the bush remover
toward the bush, and drive both the pressing ring
and bolt in to press the bush out.
Pressing In
Place the flat section of the remover toward the
bush, and then drive the bush, pressing ring, and
bolt in to install the bush.
Bush