Sym VS150 - Muffler; Rear Wheel

17. REAR WHEEL / REAR FORK / REAR CUSHION
17-3
Muffler
Removal
Loosen the 2 nuts from exhaust muffler front side.
Loosen the 3 mounting bolts by exhaust muffler
right side.
Remove the exhaust muffler.
Installation
Install in reverse order of removal procedures.
Caution
Replace the front side muffler pipe gasket if worn
or deformed.
Torque Value
For mounting bolt: 3.2 ~ 3.8kgf-m
For mounting nut: 1.0 ~ 1.2kgf-m
Rear Wheel
Removal
Remove the exhaust muffler.
Remove the lower bolt of the right side rear
cushion.
Remove 2 bolts of the rear fork.
Remove 1 nut of the rear wheel shaft, and then
remove outside collar.
Remove the rear fork, fork inside collar, and then
remove the rear wheel.