Chapter 2 TL1 Command Syntax and Description
Retrieve PM (RTRV-PM)
116 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
Retrieve PM (RTRV-PM)
This command displays the current set of performance monitoring data for one input
channel.
This command has a default access level of USER.
Syntax
RTRV-PM:[<tid>]:<aid>:[<ctag>]::<keyword>[,[<startdat>][,<starttim>],
[<stopdat>],[<stoptim]];
Parameter Value Description
<aid> IOC[m]-GPS GPS input on either of the two IOC modules.
IOC[m]-PRS PRS input on either of the two IOC modules.
IOC[m]-INP[p] INP input on either of the two IOC modules.
Table 2-26. RTRV-PM – Keywords for all <aids>
<keyword> Description
FFOFF-60 1-Minute measurements of Fractional Frequency Offset stored for 24 hours.
MTIE MTIE measurements for the current 600-second observation window, displayed in
1 ns resolution.
MTIE24 MTIE measurement over the previous 24-hour period of 1 ns resolution data.
PHASE 1 second phase data for the current 60 seconds of 100 ps resolution data.
PHASE1S 1 second phase data reported up to 24 hours of 1 ns resolution data.
PHASE1M 1 minute phase data reported up to 10800 minutes of 1 ns resolution data.
TDEV24 TDEV measurement over the previous 24-hour period, displayed in ns as a decimal
value.
Table 2-27. RTRV-PM Keyword Modifier Fields
Field Description
<startdat> Starting date for data sample.
<starttim> Starting time for data sample.
<stopdat> Stopping date for data sample.
<stoptim> Stopping time for data sample.