EasyManuals Logo

Symmetricom TimeProvider 1000 Reference Guide

Symmetricom TimeProvider 1000
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #140 background imageLoading...
Page #140 background image
Appendix A
140 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
Table A-2. System Commands
Command Description
Copy Memory (CPY-MEM), on
page 36
Saves a module’s Istate in another module’s flash memory
Retrieve Date (RTRV-DAT), on
page 99
Retrieves the system date, time, and local offset
Edit Date (ED-DAT), on page 44 Changes the system date and time
Retrieve Equipment
(RTRV-EQPT), on page 101
Retrieves currently provisioned equipment parameters
Edit Equipment (ED-EQPT), on
page 45
Used to provision equipment parameters
Retrieve Sync (RTRV-SYNC), on
page 123
Retrieves equipment parameters associated with provisioning of
the synchronization interfaces for the system inputs and outputs
Edit Sync (ED-SYNC), on page 55 Changes factory settings and input and output port parameter
settings
Retrieve Circuit Identification
(RTRV-CKTID), on page 84
Retrieves the circuit ID for the specified input or output
Edit Circuit Identifier (ED-CKTID),
on page 41
Changes the circuit ID for the specified input or output
Retrieve Attribute (RTRV-ATTR),
on page 76
Retrieves the alarm level set for a specified alarm
Initialize Event Log (INIT-LOG), on
page 66
Clears the event log on the IMC module
Retrieve Log (RTRV-LOG), on
page 109
Retrieves all events in the event log
Initialize System (INIT-SYS), on
page 67
Initializes the specified module, or the system
Retrieve System Mode
(RTRV-SYS-MODE), on page 125
Retrieves the TimeProvider’s currently provisioned system
operating mode
Set System Mode
(SET-SYS-MODE), on page 134
Provisions the TimeProvider system’s operating mode to SSU,
SUB, or PRR
Operate Alarm Cutoff
(OPR-ACO-ALL), on page 69
Deactivates (opens) the minor, major, and critical audible alarm
relays
Set Source Identifier (SET-SID),
on page 133
Provisions the TimeProvider system’s source identifier (SID)
Retrieve Alarm Condition
(RTRV-ALM), on page 73
Retrieves information on currently active alarms

Table of Contents

Other manuals for Symmetricom TimeProvider 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 1000 and is the answer not in the manual?

Symmetricom TimeProvider 1000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 1000
CategoryClock
LanguageEnglish

Related product manuals