097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 87
Chapter 2 TL1 Command Syntax and Description
Retrieve Condition (RTRV-COND)
Retrieve Condition (RTRV-COND)
This command retrieves information about the current state and status of system
components.
This command has a default access level of USER.
Syntax
RTRV-COND:[<tid>]:[<aid>]:[<ctag>];
Parameter Value Description
<aid> (null) or
ALL
Retrieves all state and status information for the entire
system.
SYS Retrieves expansion panel connectivity status and any alarm
events associated with the expansion panel.
Note: This information is reported by the active IOC.
IMC Retrieves all conditions related to the Information
Management Card module.
IOCm Retrieves current setup and conditions related to the
system-level functions of the Input/Output Card module
specified by m.
m = “1” for the slot marked “IOC 1" on the main shelf
m = “2” for the slot marked “IOC 2" on the main shelf
Notes:
If neither IOC is active, the information for the input and
output components and some of the system components
are determined by the IOC1 module if it is installed, or
the IOC2 module if the IOC1 module is not installed.
If either an IOC1(2)EQPT or IOC1(2)COMM alarm is
active, then no IOC1(2) information is displayed.
GPS Retrieves GPS input state and any alarm events associated
with the GPS input.
PRS Retrieves PRS input state and any alarm events associated
with the PRS input.
INPp Retrieves input state and any alarm events associated with
the input specified by p.
p = “1” for the input marked INP 1 on the Input
Connector module
p = “2” for the input marked INP 2 on the Input
Connector module
Note: This information is reported by the active IOC.
OUTg Retrieves status of the output group specified by g.
g = “A” for the group marked “A” on the main shelf
g = “B” for the group marked “B” on the main shelf
g = “C” for the group marked “C” on the main shelf
g = “D” for the group marked “D” on the main shelf
Note: This information is reported by the active IOC.