097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 125
Chapter 2 TL1 Command Syntax and Description
Retrieve System Mode (RTRV-SYS-MODE)
Retrieve System Mode (RTRV-SYS-MODE)
This command retrieves the TimeProvider’s currently provisioned system operating
mode. The response is one of the following values:
SSU – The TimeProvider is provisioned in the Synchronization Supply Unit
operating mode. In SSU mode, the system provides compliance with G.812,
GR1244, and GR-378.
SUB – The TimeProvider is provisioned in the Subtending SSU operating mode.
In SUB mode, the system provides composite clock input tracking (phase
following) compliant with GR-378.
PRR The TimeProvider is provisioned in the Primary Reference Receiver
operating mode. In PRR mode, the GPS input is the only reference available for
the system and the BesTime algorithm is engaged.
This command has a default access level of USER.
Syntax
RTRV-SYS-MODE:[<tid>]::[<ctag>];
Example
To retrieve the currently provisioned system operating mode:
Input
RTRV-SYS-MODE:::TP1000;
Response Example
TP-SSU 05-02-10 13:37:39
M TP1000 COMPLD
SYS,EQPT:SYSMODE,SSU
;
Autonomous Message
None
To Next Page
Loading...
Need help?
General
