097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 141
Appendix A
Retrieve BesTime Status
(RTRV-BESTIME-STAT), on
page 79
Displays the BesTime status, the data indicates predicted
BesTime ensemble information
Retrieve Built-In Self Test
(RTRV-BIST), on page 81
Displays all currently active faulted built-in self test information
for either the IMC or IOC or both
Retrieve Condition (RTRV-COND),
on page 87
Retrieves information about the current state and status of
system components
Retrieve Craft Data
(RTRV-CRAFT), on page 92
Retrieves information about the system state, clock mode of
operation, input provisioning, and output provisioning
Retrieve GPS Status
(RTRV-GPS-STAT), on page 103
Displays the position of the GPS receiver, UTC time and status
information for each of the GPS satellites in view
Retrieve Header (RTRV-HDR), on
page 104
Displays the response header information, including the system
identifier (<sid>), and the system date and time
Retrieve Inventory (RTRV-INV), on
page 105
Retrieves the system inventory
Retrieve LED Status (RTRV-LED),
on page 107
Retrieves the current state (color) of the various LED indicators
that are on the panels of the IMC and IOC modules
Retrieve Network Equipment Type
(RTRV-NETYPE), on page 113
Retrieves the network equipment (NE) type from the unit
Retrieve NTP Information
(RTRV-NTP-PEER), on page 114
Retrieves information about the NTP peer server
Remove Equipment (RMV-EQPT),
on page 71
Allows the TimeProvider to test (ping) for network connectivity
Table A-3. Performance Monitoring Commands
Command Description
Retrieve PM (RTRV-PM), on
page 116
Displays the current set of performance monitoring data for one
input channel
Delete Performance Monitoring
Data (DLT-PM-DATA), on page 38
Deletes the current set of performance monitoring data for one
input channel
Set Threshold (SET-TH), on
page 136
Sets the alarm threshold for performance monitored data, for
example MTIE and Fractional Frequency Offset
Retrieve Threshold (RTRV-TH), on
page 126
Displays the alarm level set for a particular alarm
Set Attribute (SET-ATTR), on
page 131
Sets the alarm level that an event generates
Table A-2. System Commands (Continued)
Command Description