TDE MACNO DSC-03N - Page 3

User manual 1-2
DSC/DSCT Series
9. AVAILABLE DATA FROM KEYPAD...................................................................................................... 9-1
9.1. PARAMETERS ................................................................................................................................. 9-1
9.2. CONNECTIONS ............................................................................................................................... 9-2
9.3. MAGNITUDES WHICH MAY BE DISPLAYED ................................................................................ 9-3
10. SETTING AND CALIBRATION ......................................................................................................... 10-1
10.1. ADAPTATION WITH MOTOR .................................................................................................... 10-1
10.2. SETTING REFERENCES AND SPEED LIMITS ........................................................................ 10-1
10.3. SETTING MINIMUM SPEED, MAXIMUM SPEED AND SPEED RANGE SIGNAL LEVEL....... 10-1
10.4. SETTING OF THE PEAK CURRENT LIMIT VALUES AND CURRENT RANGE ...................... 10-2
10.5. CURRENT LOOP AUTO-TUNING COMMAND ......................................................................... 10-3
10.6. RESOLVER PHASE AUTO-TUNING COMMAND ..................................................................... 10-3
11. DESCRIPTION OF THE SPEED REGULATION .............................................................................. 11-1
11.1. EXPLANATION OF THE BLOCK-DIAGRAMS........................................................................... 11-1
11.2. BLOCK DIAGRAM OF THE REGULATION .............................................................................. 11-1
11.3. SPEED REFERENCE BLOCK ................................................................................................... 11-1
11.4. RAMP AND SPEED LIMITS BLOCK.......................................................................................... 11-2
11.4.1. STOP IN PLACE........................................................................................................................ 11-3
11.5. SPEED REGULATOR AND CURRENT LIMITS ........................................................................ 11-3
11.6. CURRENT LIMITS...................................................................................................................... 11-4
11.7. THERMAL MOTOR PROTECTION............................................................................................ 11-5
11.8. LOGIC SEQUENCES ................................................................................................................. 11-5
12. REPLACING AN SC DRIVE WITH A DSC (SCT WITH A DSCT).................................................... 12-6
13. POSITIONER ..................................................................................................................................... 13-1
13.1. USE OF THE BRUSHLESS MOTOR DRIVE AS POSITIONER................................................ 13-1
13.2. ZERO-POSITION SEARCH........................................................................................................ 13-2
13.3. POSSIBLE USES ....................................................................................................................... 13-4
13.3.1. TWO SPEEDS AND TWO POSITIONS .................................................................................... 13-4
13.3.2. TWO ABSOLUTE POSITIONS WITH LIMIT SWITCH.............................................................. 13-5
13.3.3. SPEED, POSITION WITH INITIAL ABSOLUTE NUMBER....................................................... 13-6
13.4. POSITIONER IMPROVEMENTS ............................................................................................... 13-6
14. FREQUENCY INPUT(OPTIONAL).................................................................................................... 14-1
14.1. END OF MOVEMENT LOGIC OUTPUT .................................................................................... 14-2
14.2. IMPROVEMENTS FOR THE FREQUENCY REFERENCE INPUT ........................................... 14-2
15. DIMENSIONS AND SIZES ................................................................................................................ 15-3
15.1. DIMENSIONS AND SIZES OF DSC DRIVES ............................................................................ 15-3
15.2. DIMENSIONS AND SIZES OF DSCT DRIVES.......................................................................... 15-4