User Manual 1-2
DSC/DSCT series
1.1. WARNINGS
•
Carefully read the manual before installing and using the equipment.
•
The manufacturer declines any liability for any improper use of the equipment different from
that set out in the manual.
•
No alteration or operation not prescribed by the manual is permitted except with the express
authorisation of the manufacturer, and must by carried out by qualified personnel. Failure to
observe this rule will mean that the manufacturer shall decline any liability for any possible
consequences and the guarantee will cease to have effect.
•
The setting up and installation may only be carried out by qualified personnel who are
responsible for observance of the safety rules imposed by the laws in force.
•
If the drive is installed without the proper E.M.C. filter and plugged in low voltage public mains
supply, it can cause radio frequency noises or interferences.
•
In the specific case for which the equipment is being used it is necessary to take into account
the safety regulations for the prevention of accidents. The installation, cabling and opening of
the equipment and the drive must all be done with the voltage supply cut off.
•
Equipment and drives must be installed in a contact proof case with IP grade protection which
complies with the norms.
•
Position the equipment in such a way that access for maintenance operations is easy and that
there is no danger of interference with moving parts.
•
Ensure that there is always sufficient ventilation to discharge what is lost from the drive.
•
Do not use extinguishers containing water when there is fire in proximity to the equipment.
•
Avoid at all times the penetration of water and other fluids into the equipment.
•
Any work carried out within the equipment must be done with the supply of voltage cut off. As
there are condensers wait at least 8 minutes before accessing the inside of equipment to work
on it.
To Next Page
Loading...