TDE MACNO DSC-03N - Page 31

User manual 9-4
DSC/DSCT Series
ALARMS STATE (H=0N L=OFF)
A 9 Overspeed L-H
A 10 Power circuit minimum voltage L-H
A 11 Power circuit overvoltage L-H
A 12 Wrong input configuration L-H
A 13 Wrong pole setting L-H
A 14 Wrong power connections L-H
LOGIC INPUTS STATE (H=ON L=OFF)
i 1 Logic input iL1 state L-H
i 2 Logic input iL2 state L-H
i 3 Logic input iL3 state L-H
i 4 Logic input iL4 state L-H
i 5 Logic input iL5 state L-H
i 9 On-line function state L-H
i 10 Torque enable function state L-H
i 11 External consent function state L-H
i 12 Ref 1 enable function state L-H
i 13 Ref 2 enable function state L-H
i 14 Limit switch 1 function state L-H
i 15 Limit switch 2 function state L-H
i 16 External current limit enable function state L-H
i 17 Alarm reset function state L-H
i 18 Start pos. 1 function state L-H
i 19 Start pos. 2 function state L-H
i 20 Pos./Speed function state L-H
i 21 Reference direction from volt./freq. conv. function state L-H
i 22 Enable ramp function state L-H
i 23 Alternate start POS1/POS2 L-H
i 24 Not available
i 25 L = external analog ref., H = ref. selected by c14 L-H
LOGIC OUTPUTS STATE (H=ON L=OFF)
o 1 Logic output oL1 state L-H
o 2 Logic output oL2 state L-H
o 9 Drive ready function state L-H
o 10 Motor thermal device alarm function state L-H
o 11 Speed over minimum function state L-H
o 12 Drive on line function state L-H
o 13 CW rotation function state L-H
o 14 Saturation speed state function state L-H
o 15 Ramp end function state L-H
o 16 Speed in range function state L-H
o 17 Current in range function state L-H
o 18 Blocked motor function state L-H
o 19 Stop in position function state L-H
o 20 Ramp active L-H
o 21 Deceleration ramp L-H
o 22 Stop in POS1 L-H
o 23 Stop in POS2 L-H
o24
o 25 Movement end L-H