28
8303460000 Rev A IA672-04-01-Rev. I
Static IP
For many automation systems, the instrument IP addresses are set to static. This
prevents the IP addresses from changing, which may happen if a DHCP server is
used to generate the address.
If the Static IP radio button is selected, the web page will allow you to change the
following settings:
Note
If the new IP address is already used by another device on the subnet
(creating a duplicate IP), the new address is rejected and the power supply
continues to use its old address. The front and rear panel will blink until any
front panel button is pressed
Note
Hostname addressing is not supported when using a static IP.
To Next Page
Loading...
