TDK-Lambda Z+ series - Chapter 9: Status, Fault and SRQ Registers

117
Subsystem
Level
Display Function Level Display Parameter Level Display Description
Trigger Setting
triG
INIT
iNiT
INIT
iit
Initialization
(Refer to command INIT)
ready for trigger.
TRIG
TriG
Continue
CoNT
ENA
ENA
refer to command
INIT:CONT
DIS
di
Trigger
IN (input
trigger)
tr
. I
BUS (via Software
or front Panel),
B
refer to command
TRIG:SOUR
EXT (Analog)
ET
Trigger delay
tr
. d
0-65.44sec
0 . 100
refer to command
TRIG:DELAY.
Fine and Course modes
Trigger OUT
tr
. O
OFF
OFF
refer to command
OUTP:TTLT:MODE
Trigger
TriG
Function Strobe
FSTR
Programming
rOG
LOAD List or
Wave data
Od
L1…L4
2
Refer to commands
LIST:LOAD and
WAVE:LOAD
COUNter (set
repeat time)
CO
1…9999
12
(Refer to LIST:COUN
and WAVE:COUN) allow
course and fine setting
STEP setting
te
ONCE
ONCE
(Refer to LIST:STEP and
WAVE:STEP)
AUTO
ATO
ABORt
execution
bor
YES
ES
(Refer to command
ABORt)
Table 8-1: Trigger and Programming front panel menu
NOTE:
At AC power ON the display shows last selected program list but dosen’t load it from memory.
NOTE:
If during program selection L1-L4, display shows ”ERR” message then program memory is empty or
power supply is in initiated state. Select “ABORt” to EXIT from initiate state.