TDK-Lambda Z+ series - Page 7

3.9.3 Wire Termination .....................................................................................................................................................35
3.9.4 Noise and Impedance Effects .......................................................................................................................... 35
3.9.5 Inductive Loads ........................................................................................................................................................ 35
3.9.6 Making the Load Connections ........................................................................................................................35
3.9.7 Connecting Single Loads, Local Sensing (default) .............................................................................. 37
3.9.8 Connecting Single Loads, Remote Sensing ............................................................................................ 37
3.9.9 Connecting Multiple Loads, Radial Distribution Method ............................................................... 37
3.9.10 Multiple Load Connection with Distribution Terminals ................................................................ 38
3.9.11 Grounding Outputs ............................................................................................................................................. 38
3.10 Local and Remote Sensing ..........................................................................................................39
3.10.1 Sense Wiring ............................................................................................................................................................. 39
3.10.2 Local Sensing ........................................................................................................................................................... 39
3.10.3 Remote Sensing ..................................................................................................................................................... 40
3.10.4 J2 Sense Connector Technical Information...........................................................................................40
3.11 Repackaging for Shipment .........................................................................................................40
CHAPTER 4: FRONT/REAR PANEL CONTROLS AND CONNECTORS
4.1 Introduction........................................................................................................................................ 41
4.2 Front Panel Display and Controls .............................................................................................. 41
4.3 Rear Panel Connectors ................................................................................................................... 43
4.3.1 J1 Connector Terminal and Function .......................................................................................................... 45
4.3.2 J3 Connector Terminal and Function .........................................................................................................46
4.4 Front Panel Display Messages .....................................................................................................47
4.5 Navigating the Main Menu .......................................................................................................... 48
4.5.1 Introduction ................................................................................................................................................................48
4.5.2 Exiting the Main Menu ........................................................................................................................................48
4.6 Navigating Communication Menu ............................................................................................49
4.6.1 Introduction ................................................................................................................................................................ 49
4.6.2 Exiting the Communication Menu ..............................................................................................................50
4.7 Navigating the Protection Menu ................................................................................................ 50
4.7.1 Introduction ............................................................................................................................................................... 50
4.7.2 Exiting the Protection Menu............................................................................................................................. 50
CHAPTER 5: LOCAL OPERATION
5.1 Introduction ........................................................................................................................................ 51
5.2 Standard Operation .........................................................................................................................51
5.2.1 Constant Voltage Mode and Voltage Setting ........................................................................................ 51
5.2.2 Constant Current Mode and Current Setting ........................................................................................ 51
5.2.3 Automatic Crossover ............................................................................................................................................. 52
5.2.4 Output On/Off Control ........................................................................................................................................ 52
5.2.5 Safe Start and Auto-Restart Modes .............................................................................................................. 52
5.2.6 Viewing Software Revision ................................................................................................................................ 52
5.3 Alarms and Protective Functions ................................................................................................53
5.3.1 Introduction ................................................................................................................................................................ 53
5.3.2 Over Voltage Protection ..................................................................................................................................... 53
5.3.2.1 Setting the OVP Level ....................................................................................................................................... 53
5.3.2.2 Resetting the OVP Circuit ............................................................................................................................... 54
5.3.3 Under Voltage Protection and Under Voltage Limit ........................................................................ 54
5.3.3.1 Setting the UVP/UVL Mode and Level ....................................................................................................54
5.3.3.2 Activated UVP Alarm .........................................................................................................................................54
5.3.4 Foldback Protection ............................................................................................................................................. 54
5.3.4.1 Setting the Foldback Protection ............................................................................................................... 55
5.3.4.2 Activated FOLD Alarm ...................................................................................................................................... 55
5.3.5 Protection Delay ...................................................................................................................................................... 55