TDK-Lambda Z+ series - Page 8

5.3.5.1 Setting the Protection Delay ........................................................................................................................ 55
5.3.6 Over Temperature Protection .......................................................................................................................... 55
5.3.7 AC Fail Alarm .............................................................................................................................................................. 55
5.4 Series Operation ............................................................................................................................... 56
5.4.1 Series Connection for Increased Output Voltage ................................................................................56
5.4.2 Series Connection for Positive and Negative Output Voltage .................................................... 56
5.4.3 Remote Programming in Series Operation .............................................................................................57
5.5 Parallel Operation ............................................................................................................................58
5.5.1 Introduction ................................................................................................................................................................ 58
5.5.2 Basic Parallel Operation ....................................................................................................................................... 58
5.5.2.1 Master Unit Set Up .............................................................................................................................................. 58
5.5.2.2 Slave Unit Set Up ................................................................................................................................................. 59
5.5.2.3 Setting Over Voltage Protection ................................................................................................................ 59
5.5.2.4 Setting Foldback Protection ......................................................................................................................... 59
5.5.2.5 Connection to Load ........................................................................................................................................... 59
5.5.3 Advanced Parallel Operation ........................................................................................................................... 61
5.5.3.1 Setting Up of Master Unit ............................................................................................................................... 61
5.5.3.2 Setting Up of Slave Units ................................................................................................................................ 61
5.6 Daisy-Chain Connection ................................................................................................................ 62
5.7 Rear Panel (J3 Connector) Functions and Settings ..............................................................62
5.7.1 External Shut Off Function ................................................................................................................................. 63
5.7.2 Interlock Function - Analog On/Off. (Enable/Disable) .....................................................................63
5.7.3 Auxiliary Programmed Function Pin 1 and Pin 2 .................................................................................64
5.7.4 Power Supply OK Signal ...................................................................................................................................... 65
5.8 Rear Panel (J1 Connector) Functions ......................................................................................... 65
5.8.1 CV/CC Signal ............................................................................................................................................................... 65
5.9 Parameter Setting Memory .......................................................................................................... 66
5.9.1 Default Setting .......................................................................................................................................................... 66
5.9.2 Reset ................................................................................................................................................................................ 66
5.9.3 Last Setting Memory ............................................................................................................................................. 66
5.9.4 Save <1..4> ................................................................................................................................................................... 67
5.9.5 Recall <1..4> ................................................................................................................................................................ 67
CHAPTER 6: REMOTE ANALOG PROGRAMMING
6.1 Introduction........................................................................................................................................69
6.2 Local/Remote Analog Control ..................................................................................................... 69
6.3 Local/Remote Analog Indication ................................................................................................69
6.4 Remote Voltage Programming of Output Voltage and Current .....................................70
6.5 Remote Resistor Programming of Output Voltage and Output Current ..................... 71
6.6 Programming Monitoring of Output Voltage (V_MON) and Current (I_MON) ........72
CHAPTER 7: Serial RS232/RS485 and USB Interface
7.1 Introduction ........................................................................................................................................73
7.2 Configuration .....................................................................................................................................73
7.2.1 Default Setting .......................................................................................................................................................... 73
7.2.2 Address Setting ........................................................................................................................................................ 73
7.2.3 Communication Interface Selection ..........................................................................................................73
7.2.4 Baud Rate Setting .................................................................................................................................................... 74
7.2.5 Language Selection (RS232/RS485, USB) .................................................................................................. 74
7.2.6 Setting Unit in Remote, Local Lockout or Local Mode ..................................................................... 74
7.3 Rear Panel RS232/485 Connector ............................................................................................... 75
7.4 Connectig Power Supply To RS232 Or RS485 BUS ................................................................76
7.5 Rear Panel USB Connector ............................................................................................................77
7.7 GEN Protocol (GEN series communication language) ......................................................... 78