- 101 -
EO1-11115
MA-186-100 SERIES
Paper roll wrinkles.
Cause 1: Paper roll is not placed correctly, or placed on the skew.
Measure: Place the paper roll correctly. (Refer to page 10.)
Cause 2: Failure of the printer itself
Measure: Ask the store where purchased.
Printer prints nothing.
Cause 1: Ink ribbon is not installed.
Measure: Install the Ink ribbon. (Refer to page 93.)
Cause 2: Ink ribbon reaches its life, deteriorates, or is damaged.
Measure: Replace the Ink ribbon with a new one.
Cause 3: Failure of the printer itself
Measure: Ask the store where purchased.
Printing as a whole is too light.
Cause 1: Ink ribbon reaches its life, deteriorates, or is damaged.
Measure: Replace the Ink ribbon with a new one. (Refer to page 93.)
Printing gets stained.
Cause 1: Printer drum gathers paper dust.
Measure: It is necessary to clean the inside of the printer, therefore ask the store where purchased.
Printing is uneven or too light.
Cause 1: Ink ribbon reaches its life, deteriorates, or is damaged.
Measure: Replace the Ink ribbon with a new one. (Refer to page 93.)
Abnormal sound generates.
Cause 1: Paper roll or ink ribbon is not placed correctly.
Measure: Place the paper roll or ink ribbon correctly. (Refer to page 10 or 93.)
Cause 2: Failure of the printer itself
Measure: Ask the store where purchased.
Stamp does not work.
Cause 1: Stamp is not installed correctly.
Measure: Install the stamp correctly. (Refer to page 95.)
Cause 2: Failure of the stamp mechanism
Measure: Ask the store where purchased.
Print of the stamp is too light.
Cause 1: Stamp ink is not enough.
Measure: Replenish the ink. (Refer to page 95.)
To Next Page
Loading...
