FS-2700 Owner’s Manual Guest Check Functions
3-5
3.2.2 Guest Count
A guest count can be required for the Order Type by the REQ
GUEST CNT flag in the Order Type table. The Order Type is
determined by the Job Code of the User logged in.
• This setting requires a number of guest entry before the
check is sent.
• An additional setting, PROMPT # GUEST in the Station
Setup table, can require a guest count entry before a menu
item is entered.
A default entry can be assigned to an Order Type using the
DEFAULT GUEST COUNT flag in the Order Type table, so the
server does not have to make an entry.
This key type does not apply if the workstation is set up to track
check cover by Meal Count rather than Guest Count. That
option is GUEST CNT in the Station Setup table.
Procedure
1. Index the number in the party for this guest check.
2. Press {GUESTS}.
OR
1. Press {GUESTS}.
2. Screen prompts:
Enter guest count
3. Index the number in party and press {TOTAL}.
• To accept the default guest count, press {TOTAL} without
entering a number first.
To Next Page
Loading...
Need help?
General
