TEC FS-2700 - Combining Checks to One Table

Guest Check Functions FS-2700 Owner’s Manual
3-38
3.9.5 Combining Checks to One Table #
This procedure will either add items from both checks to the resulting
check, or add a separate check to the table number. It depends on
the setting ONE CHK/TBL in the System Setup/System Config table.
1. Recall the check.
2. Index the number of the new table, press {TABLE~#}.
3. Prompt line displays message:
Change table?
1- YES, 0 - No
4. Index {1} for YES and press {TOTAL}.
5. Screen prompts:
Add Check
1 – YES, 0 - No
6. Index {1} for YES and press {TOTAL}.
7. Depending on setting of ONE CHECK/TABLE option:
• If YES – items from both checks are combined for this table.
• If NO – there are two separate checks created for this table.
8. End the service round by pressing {TOTAL}, {MEDIA} or
{PRINT~CHECK}.