TEC TECDrive20-EU Series - Page 49

TECDrive20-EU Series Inverter Function parameters
-44-
Function
code
Name
Description
Default
Modify
inverter will stop; otherwise, the inverter stops in
the time set by P01.24.
T
Stop speed
A
Ramp reference
frequency
Output frequency
Frequency
P01.24 P01.17
B
C
Running A
Running B
Running C
Setting range: 0.00–100.00s ( valid only when
P01.16=1)
P01.18
Power-on
terminal
running
protection
selection
When the running command channel is the
terminal control, the system will detect the state
of the running terminal during powering on.
0: The terminal running command is invalid when
powering on. Even the running command is
detected to be valid during powering on, the
inverter won't run and the system keeps in the
protection state until the running command is
canceled and enabled again.
1: The terminal running command is valid when
powering on. If the running command is detected
to be valid during powering on, the system will
start the inverter automatically after the
initialization.
Note: This function should be selected with
cautions, or serious result may follow.
0
○
P01.19
Action selected
when running
frequency less
than frequency
lower limit
(valid when
frequency
lower limit is
larger than 0)
0x00–0x12
Ones place:
0: Run at the frequency lower limit
1: Stop
2: Sleep
Tens place: Stop mode
0: Coast to stop
1: Decelerate to stop
0x00
◎
P01.20
Wake–up–from
-sleep delay
This function code determines the
0.0s
○