Setting range: 0.00Hz/s–P00.03 (the max.
frequency)
After the power loss of the grid, the bus voltage
drops to the sudden frequency-decreasing point,
the inverter begin to decrease the running
frequency at P11.02, to make the inverter
generate power again. The returning power can
maintain the bus voltage to ensure a rated
running of the inverter until the recovery of
power.
Note:
Adjust the parameter properly to avoid the
stopping caused by inverter protection during
the switching of the grid.
Prohibit the input phase loss protection to
enable this function.
To Next Page
Loading...
