You don’t have to save every time when this hint appears. You can make all wished
changes and save the configuration at the end. Please check the box “restart after
saving” and then press the “Save configuration” button.
After the restart, all changes are applied.
3.3 System Information tab
Figure 3-3: System Information tab
On the tab “System Information“, some status information about the device is
displayed. You can check the version number of the application firmware and the
bootloader or the unique MAC address of the device. The version number registers of
the switch and PHY chips are displayed for information only.
MediaGateway UUID: Since version 4.1.12 the UUID is shown. This UUID is need for
activation of extra features.
MAC address: This MAC address should be the same as on the label on the bottom of
the device.
IP address: You can change the IP address of the host microcontroller (Webserver)
here. If you want to use multiple devices in one network, you must configure a unique
IP address for each device here.
Note: If you forgot the IP address of your device you can reset it to default as described
in CHAPTER 2.2.2
To Next Page
Loading...
Need help?
General