EasyManuals Logo

Technica Engineering MEDIAGATEWAY User Manual

Technica Engineering MEDIAGATEWAY
95 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
MEDIAGATEWAY User Manual
39
Prevent Sleep Port: This option is available if the function “Prevent sleep” on “Control
panel” tab is deactivated.
This port is monitored: If there is incoming traffic on this port, the
MediaGateway doesn’t fall asleep.
This port is not monitored: The MediaGateway can go asleep, even if there is
incoming traffic on this port.
Mirroring: On each switch only on port can be a mirroring port. Please select the ports
to be mirrored
SFP option: Here must be chosen the correct SFP module if any
is plugged in.
Fiber module: please select this option for fiber optical
SFP-modules.
RJ45 module: please select this option for copper modules.
Base-T1 / BroadR-Reach® module: please select this option for a BASE-T1
modules from Technica-Engineering GmbH
Speed: If no autonegotiation is not available, please select the speed of the SFP
module 100BASE-T1 for 100Mbps and 1000BASE-T1 for 1000Mbps
BASE-T1 / BroadR-Reach® mode: please configure as slave if the connected device is
master and the other way around. This is only visible, if a BASE-T1 SFP Module is used.
Module information: Based on selected SFP Module and detected hardware, different
information about the SFP Module is displayed here.
Detected features: Based on selected SFP Module and detected hardware, different
information about the features of the SFP Module is displayed here.
Drop ingress packets with…:
Inner VLAN IDs: as many as wished values between 0x1 and 0xFFF can be defined
separated by “,” [E.g.: 100, 101, EDF, …]. It is a filter for incoming traffic. Data with
configured VLAN-ID will be dropped and not forwarded, when incoming on this port.
Source IP: one IP address can be configured here. It is a filter for incoming traffic. Data
with configured IP address as source IP address will be dropped and not forwarded,
when incoming on this port.
Destination IP: one IP address can be configured here. It is a filter for incoming traffic.
Data with configured IP address as destination IP address will be dropped and not
forwarded.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technica Engineering MEDIAGATEWAY and is the answer not in the manual?

Technica Engineering MEDIAGATEWAY Specifications

General IconGeneral
BrandTechnica Engineering
ModelMEDIAGATEWAY
CategoryGateway
LanguageEnglish