TechniSat DIGITRADIO 585

64
When switching on for the first time, the frequency 87.5 MHz is set.
If you have already set or saved a station, the radio plays the last station set.
In the case of RDS stations, the station name appears.
Adjust the antenna to improve reception.
12.2 FM reception with RDS information
RDS is a procedure for broadcasting additional information via FM stations.
Broadcasters with RDS might, for example, broadcast their station name or the
programme type. This is shown in the display.
> The device can show the following RDS information:
RT (Radio text),
PS (Station name),
PTY (Programme type).
12.3 Manual station selection
> Press  or  in FM mode to set the desired station. The display shows the
frequency in steps of 0.05 MHz.
12.4 Automatic station selection
> Press SCAN to start the automatic scan. The station frequency runs upwards
in the display.
or
> In FM mode, hold down  or  for approx. 2 seconds to automatically
search for the next station with a strong enough signal.
If an FM station with sucient signal intensity is found, the scan stops and
the
station is played. If an RDS station is being received, the station name
appears and, possibly, radio text.
Please use manual station selection for seing weaker stations.
Under Menu > Scan seings you can set whether the scan only finds strong
stations (Strong stations only). To do so press the MENU buon and > Scan
seings > [Yes]. Confirm the selection with OK.
12.5 Seing mono/stereo
> Press the MENU buon and use  or  to select > Audio seing.