TechniSat DIGITRADIO 585

74
> Press the MENU buon and then select [Main Menu > System Seings >
Soware Update].
If you are in a submenu, select the main menu as described in Section 7.1.
> Select [Auto Update] if the DIGITRADIO 585 should search for new soware
versions periodically.
> Select [Check now] if you want to check immediately whether a new
soware version is available.
If a soware update has been located, follow the instructions on the display.
In order to find soware updates and upload them, the DIGITRADIO 585
must be connected to the Internet. Do not switch the DIGITRADIO 585 o
during the update process!
17.7 Set-up wizard
> Press the MENU buon and then select [Main Menu > System Seings >
Set-up Wizard].
If you are in a submenu, select the main menu as described in Section 7.1.
When switching on for the first time, the set-up wizard starts automatically.
> As soon as [Run now] is shown on the display, select [YES].
If you select [No], the wizard closes and you need to perform the required
seings manually.
You will be taken through the seings in various steps.
> Under [Time format], select the desired display format for the time display
(Section 17.3).
> During the next step you must select via which source the time is to be
synchronised (for more information refer to Section 17.3).
If you have selected [Update from the Net], you must then enter the time
zone and summer-/wintertime.
Depending on the time and date seings, some of the network seings are now
performed.
> Select whether the WiFi connection should remain active in standby mode as
well. Press the OK buon.
> Ensure that the device is within the reception range of the desired WiFi
network and that you have the access data. In some cases it may be
necessary to carry out some seings on the router. In this case, please refer
to the corresponding instruction manual.