TechniSat DIGITRADIO 585

55
DE
EN
FR
IT
NL
DA
PL
SK
SL
> Close the baery compartment lid carefully againto ensure that the lid
retaining tabs engage in the housing.
To operate the remote control, you will need 2 x alkaline baeries (type Micro,
1.5 V, LR03/AAA). Ensure that the polarity is correct when inserting.
- Promptly change baeries that are losing power.
- Leaking baeries can cause damage to the remote control.
- If the device is not being used for a prolonged period, remove the baeries
from the remote control.
- Important information concerning disposal: baeries can contain toxic
substances which harm the environment. Therefore, it is imperative to
dispose of the baeries according to the legal provisions in force. Never
dispose of baeries in normal household waste.
6.4 General device functionality
Seings and functions can be carried out both using the buons on the device and
with the remote control. The description of the operation in this instruction manual
refers to the buons on the remote control.
6.4.1 Switching on the device
> You can use the VOLUME/ knob (2) on the device or On/Standby (1) on
the remote control to switch the device on or back to standby.
Aer switching on for the first time, you can launch the set-up wizard
(Section 17.7). Here you can set the date and time either viaDAB/FM, Internet
or no update (manual). The device will then aempt to establish a connection
to a WLAN network. To do so, select the corresponding WiFi network and, if
required, enter the WiFi password with the remote control.
6.4.2 Switching o the device
> You can use the VOLUME/ knob (2) on the device or On/Standby (1) on
the remote control to switch the device on or back to standby. The date and
time are shown in the display.
6.4.3 Operating the device with the remote control
With the infrared remote control you can operate the most important device
functions from the comfort of your armchair. When operating the device with the
remote control, please take into account the following points:
> Point the remote control at the front of the device.
> Visual contact between the transmier and the receiver must be guaranteed.
> If the range of the remote control reduces, replace the baeries by new ones.
The maximum range is approximately 5 metres from the front of the device.