TechniSat DIGITRADIO 585

72
now established. The signal bar in the status bar of the display indicates
whether the connection has been established.
To cancel the entry, select and press the OK buon. If you make a
typing error you can delete the last leer entered using .
17.2.1 WPS connection
> Select WPS set-up if your router has the WPS function. This establishes a
direct connection to the router without having to enter the WiFi password.
If you activate WPS on your router, please observe its instruction manual.
> Start WPS on your router by pressing the corresponding buon.
> On the DIGITRADIO 585, select [Press Buon]. Take note of the instructions
on the display.
> If your router supports the WPS PIN, select PIN on the DIGITRADIO 585 and
take note of the PIN shown in the display. This PIN must then be entered on
the router.
To find out more on the current connection select Seings.
Select Manual seing, if you know your network parameters and would like
to configure them manually. Take note of the instructions on the display.
Select Delete network profile, to delete connections no longer required.
Select Allow WiFi connection in standby mode if the WiFi connection
should be retained in standby mode as well. This seing increases power
consumption but enables App control via the TechniSat CONNECT App.
17.3 Time seings
> Press the MENU buon and then select [Main Menu > System Seings >
Time and Date].
If you are in a submenu, select the main menu as described in Section 7.1.
> Select [Time/date seing] to set the time and date manually.
Use the  or  buons to select a value. Change it using the  or 
buons.
> Confirm by pressing OK.