&& "! !"!
5
!! ! !
This section contains the following information:
H how to prepare your instrument to attach the rack adapter
H how to attach the rack adapter to your instrument
If your instrument was purchased with the rack adapter attached to
your instrument, proceed to beginning on
page 17.
To convert the standard instrument to the rackĆadapted version, perform the
following steps.
1. Remove the power cord:
a. Disconnect the power cord from the power source.
b. Unplug the power cord from the rear of the instrument.
c. Grasp the end of the line cord and retaining clamp and rotate them
90_ counterclockwise (see Figure 3).
(1) Unplug
(2) Rotate
(3) Pull
(1) Unplug
(2) Rotate
(3) Pull
" %# ! $
!
!"!
To Next Page
Loading...
Need help?
General
