17
This section provides instructions on how to access the rear panel BNC
connectors of the instrument and make the front panel BNC connectors
accessible from the rear of the equipment rack.
Four BNC femaleĆtoĆfemale connectors are provided in this kit, although the
rack adapter is capable of having a total of six connections installed. Four
10Ćinch 50 W BNC cables are provided to interconnect between the instruĆ
ment front panel and the rack adapter front panel.
One 50 W BNC cable (at least 30 inches long) is required for each rear panel
BNC connector you wish to access from the front of the equipment rack.
Additional 50 W BNC cables (length determined by the application) are also
required for connections to other equipment. These cables are available
through your local Tektronix distributor.
If you do not wish to make any connectors accessible, proceed to
beginning on page 21.
To Next Page
Loading...
Need help?
General
