Telemark 880 - Page 133

p Model 880 DEPOSITION CONTROLLER y
SECTION 3.XX
e page 132 of 275 ^
To view / program film parameters...
Screen Key{s] to press
Run Time fixed MENU
MAIN MENU REVIEW FILM
REVIEW FILMS menu GO2 FILM (to select different film, if needed)
REVIEW FILMS menu arrow[s] + EDT (edit)
( Lock Code, if enabled [see Sys Config] numeric entry + ENT (enter) )
Review Films Edit menu arrow[s] + CHG (change)
Review Films Edit/Change Numeric Entry numeric entry + ENT (enter)
See Section 1.8 for Programmable Parameter List.
To set the NEXT ACTIVE PROCESS (sequencing mode only)...
Screen Key[s] to press
Run Time fixed MENU
MAIN MENU NEXT ACTIVE PROCESS
NUMERIC ENTRY MENU Digit (1-9) + ENTER
To view / program PROCESS steps (sequencing mode only)...
Screen Key[s] to press
Run Time fixed MENU
MAIN MENU REVIEW PROCESSES
Review Processes menu GO2 PROCESS (to select a different process, if
needed [process selected on numeric entry
screen by digit + ENTER])
Review Processes menu arrow[s] ; EDT (edit)
( Lock Code, if enabled [see Sys Config] numeric entry + ENT (enter) )
Review Processes Edit menu arrow[s] ; INS (insert) ; DEL (delete) ; CHG
(change) step line
Review Processes Edit/Change menu arrow[s] ; MOD (mode) ; FLM (film) ; THK
(thickness)
Review Processes Edit/Change Mode menu SKP (skip) ; STP (stop) ; AUT (auto) ; END ;
WAI (wait) ; ENT (enter)
Review Processes Edit/Change Film menu numeric entry + ENT (enter)
Review Processes Edit/Change Thickness
menu
numeric entry + ENT (enter)
To view Process Accounting History (sequencing mode only)...
Screen Key[s] to press
Run Time fixed MENU
MAIN MENU EXECUTIVE MENU
EXECUTIVE MENU PROCESS ACCNT
Process Accounting History menu arrow[s]