Telemark 880 - Page 256

p Model 880 DEPOSITION CONTROLLER y
SECTION 6.XX
e page 255 of 276 ^
The ‘f’ command sends a numeric value which has meaning when the instrument is set in a
thickness override (1,3) or rate override (2) mode. If instrument is in 0 mod, then the value is ignored.
Values from -9999999 to 9999999 allowed. Tenth Angstrom or hundredths A°/sec units.
The ‘g’ command sends a numeric value which has meaning when the instrument is set in dual
rate/thickness override (3) mode. If the instrument is in modes 0,1,2 then the value is ignored. Values
from -999999 to 9999999 hundredths A°/sec allowed
______________________________________________________________________
______________________________________________________________________
Purge all I.O Programs Group 15 –
Command h
This command clears the entire I/O program of the current bank to empty.
Purge all of I/O Program (h)
The ‘h’ command clears the entire I/O program of it’s current bank to empty. Requires =200 to
work as a safety.
______________________________________________________________________
Command: h
Mnemonic: EXCT_iopurg
Parameters: =200 as a safety.
Description: Clears entire I/O program of current bank to empty.
Returns:
[RZCD_AOK] if proper parameter value was sent.
[RZCD_ILDV] if improper value for parameter arguments.
[RZCD_ILSN] if too many arguments, wrong delimiters, etc..
External Memory Module Status Group 16 –
Command I
This command queries the Model 880 for current status of the optional external memory module <not
implemented>.
External Memory Module Status (i)
The ‘I’ command queries the Model 880 for current status of the External Memory Module.
Returns 0,1, or 2 indicating: (0) not installed, (1) installed, or (2) bogus, meaning system hung waiting for
clear key to be pressed.
Command: i
Pur
g
e all I.O Pro
g
rams
External Memor
y
Module Status