Teleste MPH241 - Audio Encoder Configuration; Rate Control for Audio Encoding; Audio Stream Container Format

32 MPH200 series video encoders WebUI user manual
Note! Only even port numbers can
be used for RTP, and then the
following odd port number shall be
used for RTCP (RFC 1889).
Note! Samplerate value has to be
same at both encoder and corre-
sponding decoders.
Usage
Proles:
Rate control:
Samplerate:
Bitrate:
Container:
RTSP Options:
Session tmeout:
AUDIO ENCODER CONFIGURATIONS page.
_________________________________________________________
Here you see how the media prole is assigned to a audio source.
_________________________________________________________
Denes audio codecs samplerate value (8/16/32/44.1 or 48 KHz). Setting a
higher samplerate value improves audio le quality and increases its size.
Denes encoded audio bitrate (8..288 kbps). The higher the rate is, the
better the quality of sound is. However this also increases the le size.
RTP (Real-time Transport Protocol) or TS (MPEG transport stream).
_________________________________________________________
Timeout for RTSP session.
Trigger Conguration
See section “Event management
system” from page 60 for more details.