33 MPH200 series video encoders WebUI user manual
_________________________________________________________
Enables or disables the trigger feature
Keeps the event state unchanged for the dened period for instance if an
event clears quickly, it does not change its state for the dened timeout,
recommended 5 seconds.
_________________________________________________________
Select the event type
The topic expression of the event
Event description, lter and values
_________________________________________________________
Destination IP address. Multicast: Multicast IP address / multicast group.
This multicast IP address has to be same at both encoder and corre-
sponding decoders. Unicast: IP address of receiving decoder.
UDP port number (0...65536). This number has to be same at both
encoder and decoder pairs. Port number needs to be even, as next odd
port is allways used for RTCP trafc.
Time-To-Live for video packets = number of hops that a packet is permit-
ted to travel before being discarded by a router
(0...255)
.
Audio streaming will automatically start after reboot. Changing autostart
does not immediately start or stop streams.
(Differentiated Services Code Point) eld lets you set bits in the stream IP
header allowing a network device to apply rules such as how the packet is
forwarded in the network and QoS (Quality of service) management.
Default = Normal audio transmission mode:
Active: Audio is transmitted.
Paused: Audio encoder is ready but paused (no packets trasmitted).
Triggered = Audio is congured with triggering feature:
Active: Audio is transmitted.
Paused: Audio encoder is ready but paused (no packets trasmitted).
Trigger conguration:
Enabled:
Timeout:
Event subscription (for triggering):
Events:
Topic Expr:
Message content lter:
Streaming Conguration:
Destination address:
Destination port:
TTL (Time To Live):
Auto start:
Quality of Service (DSCP):
Transmission mode:
To Next Page
Loading...