34 MPH200 series video encoders WebUI user manual
Audio stream multiplication
Each audio encoding prole can be assigned with ve (5) different destina-
tion addresses (primary stream and additional streams). These addresses
can be freely set to unicast, multicast or a combination of these.
The use of multiple destination addresses up to a certain degree doesn’t
load the MPU; however one should take into account that the aggregate
bit rate of all output streams does not exceed the capacity of the
100Mbps interface.
Destination IP address. Multicast: Multicast IP address / multicast group.
This multicast IP address has to be same at both encoder and
corresponding decoders. Unicast: IP address of receiving decoder.
UDP port number (0...65536). This number has to be same at both
encoder and decoder pairs.
Differentiated Services Code Point eld lets you set bits in the stream IP
header allowing a network device to apply rules such as how the packet is
forwarded in the network and QoS (Quality of service) management.
Active: Audio is transmitted.
Paused: Audio encoder is ready but paused (no packets trasmitted).
Adds new copy from stream.
Stream multiplication:
Destination address:
Destination port:
Quality of Service (DSCP/DiffServ ):
Transmission mode:
:
To Next Page
Loading...
