Teleste MPH241 - CLI Dot1 x, IGMP, Debug Commands

86 MPH200 series video encoders CLI user manual
Dot1x command
Enter the dot1x command to go to system level:
IGMP command
Enter the igmp command to go to console level:
Commands at Dot1x level:
Dot1x Configuration
Dot1x Mode [enable|disable]
Dot1x State [<portlist>] [Auto|ForceAuthorized|ForceUnauthorized]
Dot1x Server [<IP Address>]
Dot1x UDP Port [<value>]
Dot1x Secret [<Shared Secret>]
Dot1x Statistics [<portlist>]
Dot1x Reauthenticate [<portlist>] [now]
Dot1x Parameters [<parameter>] [<value>]
Commands at IGMP level:
IGMP Configuration
IGMP Status
IGMP Groups <vidlist>
IGMP Mode [enable|disable]
IGMP State <vidlist> [enable|disable]
IGMP Querier <vidlist> [enable|disable]
IGMP Router ports [<portlist>] [enable|disable]
IGMP Unregistered Flood [enable|disable]
Debug command
Enter the debug command to go to system level:
Commands at Debug level:
Debug Read Register <block> <subblock> <address>
Debug Write Register <block> <subblock> <address> <value>
Debug PHY Read <portlist> [<address>] [<page>]
Debug PHY Write <portlist> <address> <value> [<page>]
Debug Loopback [int|ext]