85 MPH200 series video encoders CLI user manual
QoS command
Enter the qos command to go to console level:
Commands at QoS level:
QoS Configuration [<portlist>]
QoS Mode [<portlist>] [tag|port|diffserv]
QoS Default [<portlist>] [<class>]
QoS Tagprio [<portlist>] [<tagpriolist>] [<class>]
QoS DiffServ [<dscpno>] [<class>]
QoS Userprio [<portlist>] [<tagprio>]
QoS Storm Control [<traffic type>] [enable|disable] [<rate>]
<class> range: low|normal|medium|high
<traffic type>: Broadcast|Multicast|Flood Unicast
Mirror command
Enter the mirror command to go to system level:
IP command
Enter the ip command to go to console level:
Commands at Mirror level:
Mirror Configuration
Mirror Port [<port>]
Mirror Source [<portlist>] [enable|disable]
Commands at IP level:
IP Configuration
IP Status
IP Setup [<ipaddress> [<ipmask> [<ipgateway>]]] [<vid>]
IP Mode [enable|disable]
IP Ping [-n <count>] [-w <timeout>] <ipaddress>
IP Arp
IP Dhcp [enable|disable]
IP tftp [enable|disable]
IP tftpget server-ip filename
IP tftpput config|image|backup server-ip filename
To Next Page
Loading...
