BRAVO – Wireless Alarm Control Panel
38
9. Operation with the System
9.1. Reviewing of Alarm events
lights on permanently in red.
Press the button to review the current alarm events.
The zone number with the newest (last in the time)
alarm is blinking and the group device indicator is
lighting on. The other zone numbers with active alarms
are lighting on. Use the arrow buttons to review the
order of the alarms as:
- arrow for scrolling to the before last alarm;
- arrow for scrolling to the first alarm. While the
zone number is selected the LED of the device enrolled
to it is blinking in yellow.
9.2. Clearing of Alarm events
The indication for the alarms will stay active until the
next arming, but can be also cleared by user manually.
To clear manually the alarms, press in sequence:
To exit from the Reviewing Alarms Mode press the
“Memory” button once again. The exit is automatic after
3 minutes if there is no pressed button.
9.3. Reviewing Troubles Mode
lights on permanently in yellow.
The panel performs two short sound signals at every
20 seconds.
Press the “Attention” button to review the current
troubles indicated from devices and/ or the panel. For
detailed description of the indicators see also items 5.1
and 5.2.
To exit from the Reviewing Troubles Mode press the
“Attention” button once again. The exit is automatic after
3 minutes if there is no pressed button.
After exit from the Reviewing Troubles Mode the sound
signalization will stop. LED indication will remain active
until restoring of the current troubles.
9.4. Reviewing of Bypassed Devices
lights on permanently in yellow.
Press the button to review the bypassed devices. The
zone number of the first bypassed device is blinking and
the group device indicator is showing its type. The LED
of the selected device is blinking in yellow. Use the
arrow buttons to review the other bypassed devices.
Press the button to review if there are bypassed
devices from other group types.
To exit from the Reviewing Bypassed Devices press the
“Bypass” button once again. The exit is automatic after
3 minutes if there is no pressed button.
9.5. Erasing the Log Memory
ATTENTION: The full list of the last 256 memory
events can be viewed via ProsTE software,
Mobile TTE and AjaxWEB web application.
To erase the log memory:
Enter in “Device enrolment” mode.
Use the arrows to select a free zone or position – it is
blinking in green.
Press and hold at the same time buttons + .
The panel will confirm the erasing with a sound
signal.
9.6. Changing Signal Strength of a Key Fob
This functionality allows the user to increase/ decrease
the strength of the emitted signal of the key fobs.
To increase the signal strength, press at the same
time the buttons + of the key fob.
To decrease the signal strength, press at the same
time the buttons + of the key fob.
Button of a MANAGER
key fob
To Next Page
Loading...
