Teletek electronics BRAVO - 2. Planning Your Wireless System

BRAVO – Wireless Alarm Control Panel
4
2. Planning Your Wireless System
In order to achieve the best efficiency of your wireless
system, prior to installation plan the location of the
control panel and the wireless devices within the
premises.
 The installation place of the control panel should be
in premises located above the ground level.
 Minimize the number of obstacles between the
control panel and the wireless devices to obtain a
stronger signal.
 The control panel should be installed in a minimum
distance of at least 2 meters far from other sources
of radio signals (Wi-Fi or Bluetooth routers, wireless
telephone stations, etc.).
ATTENTION: Do not install the panel close to
sources of strong radio fields as these can cause
interference and thus diminish the serviceability
of the system and its radio band.
 The control panel should be installed approximately
within the center of the protected premises.
The minimum distance between the panel and
enrolled peripheral devices must be 1 meter to
guarantee the proper operation of the system,
including in test mode.
 In case of installing the control panel in a corner,
leave the following minimum distances:
o 20 cm on the left side surface to provide a free
access to the USB interface input for
programming with ProsTE software;
o 5 сm on all other sides of the box for providing a
proper ventilation.
ATTENTION: The control panel installation
location should be dry and should not be
subjected to harsh temperature changes.
The control panel should be installed close to
grounding and telephone cables.
> 20 cm.
GENERAL INFORMATION
> 2 m
Power lines
Wi-Fi/ Bluetooth routers
Wireless telephone
stations
> 5 cm.
> 5 cm.
0°С
40°С
Entrance
> 1 m