3. Safety Instructions
and conformity info
The Confidea Wireless Conference system is state of
the art and has been designed to meet quality.
Nevertheless, the individual components of the
conference system can cause danger for persons and
material assets if
− the conference system is not used as intended,
− the conference system is set up by personnel not
familiar with the safety regulations,
− the conference system is converted or altered
incorrectly,
− the safety instructions are not observed.
3.1. FCC and ICES
information
(U.S.A and Canadian Models only)
3.1.1. Statements for FCC and
Industry Canada
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à
la norme NMB-003 du Canada.
The Confidea wireless equipment has been tested
and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment
and receiver.
− Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
− Consult the dealer or an experienced radio/TV
technician for help.
This Wireless discussion units and the Wireless
Access Point comply with Part 15 of the FCC Rules
and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. this device may not cause
harmful interference, and
2. this device must accept
any interference received,
including interference that
may cause undesired
operation.
Warning:
Changes or modifications made to
this equipment not expressly
approved by Televic NV may void
the FCC authorization to operate
this equipment.
To Next Page
Loading...
