− ‘Start Init’:
Pressing this control will start an initialization
cycle. The green and red Microphone Status
LEDs wil blink until the delegate unit has been
recognized as ready to log on, by the Confidea
Access Point. Once recognized , only the red
Microphone Status LEDs will blink . Now the
units are ready to initialize. Pressing the
microphone button of each unit that needs to
log on to the system , will register that unit
within the Access Point.
− ‘Save and Stop Init’:
This will stop the initialization and save the init
list to memory. To add more units, restart the
init cycle.
− ‘Clear Init List:
This will clear the init list and allow you to start
from scratch to build an init list.
To add delegate units to an existing initialization,
just start init without clearing Init list.
12.4. Service
12.4.1. Logging
Log List
On this web page, a list of events are displayed that
occurred in the access point. This will help to
diagnose the system when necessary.
− Start:
This button starts capturing the access point
events.
− Stop:
This button stops capturing the access point
events.
− Clear:
This button will clear the events that were
previously captured.
Use the MS Windows Copy-Paste facilities to export
the log list.
12.5. Encryption
12.5.1. Key Assignment
Introduction
To ensure a highly secured wireless system, the
Confidea wireless system uses an encryption
algorithm and mechanism that is fixed and cannot be
changed.
The information that is transmitted over the radio
link is encrypted with a key to make it inaccessible
for 3
rd
party equipment. This key is default and
identical for all Televic units.
Security can be increased by adding a custom key,
that is specific to a certain set-up or installation. Only
the units and access point that share the same
encryption key are able to communicate with each
other. In this way, the system has become customer
To Next Page
Loading...
