11.2.5. Step 5 – Default Screen
After successfully establishing a connection to the
WCAP and passing the password screen, the default
WCAP screen appears.
Figure 11.18 : WCAP default screen
11.3. Setting the IP address
After you successfully accessed the WCAP for the
first time (refer to 11.2 ‘First time access’) you can
customize the TCP/IP settings to allow the WCAP into
your own personal or company LAN network.
− Select the “TCP/IP settings” sub tab in the
“Setup” menu (refer to Figure 11.19: Confidea
wireless setup menu)
Figure 11.19: Confidea wireless setup menu
− In the TCP/IP settings - screen you can modify
the TCP/IP settings of the WCAP (refer to Figure
11.20).
1. The name of the installed conference system can
be customized.
2. The MAC address of the WCAP (fixed)
3. The IP address mode determines how the WCAP
will get its IP address
− Static: in this mode the IP address and
subnet mask is fixed and must be provided
in the appropriate fields.
− DHCP: DHCP stands for Dynamic Host
Configuration Protocol and is a protocol
used by the WCAP to obtain the
parameters necessary for operation in an
Internet Protocol network automatically.
This protocol reduces system
administration workload, allowing the
WCAP to be added to the network with
little or no manual configuration.
Note 11.2-1
Confidea wireless webserver has been
fully tested successfully on Windows
Internet Explorer 8 .
However , since there exists a wide
variaty of web browsers , which are
subject to regular updates , 100% correct
functionality of Confidea wireless
webserver on all browser types can not
be guaranteed, because some actions
may be blocked by specific browsers.
To Next Page
Loading...
