11. Accessing the built-
in web server
11.1. Introduction
The WCAP has a built-in web server that allows you
to set/monitor certain parameters characterizing the
wireless conference system.
The following is a step-by-step guide to give you a
general idea of how to access your WCAP.
11.2. First time access
11.2.1. Step 1 – Reset
Figure 11.1: Power connection and power switch
Figure 11.2: Reset button
Follow these steps to reset the access point (WCAP)
− Unplug ALL connections
− Connect the power cord
− Activate the WCAP by flipping the power switch
to the “on” position
− Hold down the reset button for at least 5
seconds using a fine object or stylus.
− Using the ON/OFF switch, switch the unit “off”
and back “on” for the reset to take effect
After the reset the default settings in the WCAP will
be restored. Please refer to Default Settings to get a
complete overview of all default settings.
Note:
This step is only required if the default
settings have been altered.
To Next Page
Loading...
