Televic Confidea - TCP;IP Settings; Country Selection; Admin

Confidea Wireless System Installation and User Manual
Televic Conference Systems 2012-05-11 60
− RF hardware 1 Version: Displays the RF hardware
version for the active module.
− RF hardware 2 Version: Displays the RF hardware
version for the passive module.
− RF Firmware 1 Version: Displays the RF firmware
version for the active module.
− RF Firmware 2 Version: Displays the RF firmware
version for the passive module.
12.1.2. TCP/IP settings
Identification
− System Name: Defines the user-defined system
name.
− Base MAC Address: Displays the MAC addresses
assigned to the system.
IP configuration
In this section you can configure how the system will
acquire its IP address
− IP Address Mode: Retrieves the IP address using
DHCP or Static.
DHCP: Retrieves the IP address using DHCP.
Static: The IP address is statically defined.
− IP Address: Defines the system IP address.
− Subnet Mask: Defines the system IP address
mask.
12.1.3. Country selection
Select the correct country the system is working in.
This setting will affect the available frequencies and
output power of the HF-carriers.
12.1.4. Admin
Change password
Only users that know the password are
authenticated to use and consult the Confidea WCAP
web pages!
In this section the password can be redefined:
1. Enter the OLD password
2. Enter a new password (Max. 50
characters long)
3. Confirm the new password
4. Submit the values to the server and
wait for the result.
Note:
Use this information when you contact
the service department in case you
experience problems with the system.
Note:
When pressing the ‘Save’ button, the
active settings are stored in memory and
recalled after power-down.
Note:
The old password will work as long as no
positive feedback has been received.